-
Hi,
i have some rtcm3 messages in binary format and i'm trying to find a way for reading their contents. It would be really helpful if you could write a short readme on how to use your decoder for re…
-
Hello everyone:
I use two Ublox lea-6t to testing RTKLIB on Linux,First,I use one for base station,I use str2str to transfer data from UBX to RTCM3 the command is :
./str2str -in serial://t…
-
Is it possible to use this library on the UBX M8P for RTK purpose (base-station)?
- configure dynamic model
- get the RTCM3 corrections (1005, 1077 and 1087)
If not, do you plan on supporting it,…
-
Is it possible to use this library on the UBX M8P for RTK purpose (base-station)?
configure dynamic model
get the RTCM3 corrections (1005, 1077 and 1087)
If not, do you plan on supporting it, is …
-
I have only tested with 2.4.3 b26, however if you attempt a real-time RTKNAVI in PPP Static with ublox and an RTCM3 reference base, no PPP solution will ever resolve. The same goes for PPP Static in …
-
I am trying to set up base and rover with c94 m8p modules. My base station goes into Time mode after survey completes. I launch rover node with tmode3 = 0, and it runs without any error. But I dont se…
w4zir updated
2 years ago
-
I have installed RTKLIB on my Windows 10 machine using a U-Blox ZED-F9P as my rover and an NTRIP client as my base. I have set the input of the rover to serial and the format to u-blox and the base st…
-
I'm struggling with setting up an RTK solution for Pixhawk.
Please help!
This is my config:
BASE:
U-blox NEO M8T (NEO-M8T Time & RAW Triple Band +HMC5983 Tallysman TW2710 for RTK)
Setup in U-center se…
-
Hello!
Thank you for this great opensource project!
I have U-Blox ZED-F9P receiver and antenna U-Blox ANN-MB-00-00. I'm trying to [create precise GNSS tracks](https://forum.openstreetmap.org/vie…
-
Would it be too much to ask if there would be a small change in the strsvr so that it could be set to pass over also the in rtklib unsupported RTCM message types like 1230 in a RTCM3 to RTCM3 type str…