-
I want to flash my Sonoff ZigBee Stick with Ptvo. I take the sonoff_3_usb_dongle_plus file and adjust it using the firmware configuration program. I set the signal strength to 20.
z2m found the dev…
-
Hi.
in Test Version support of an HX711 is included.
Instead of this I want to use established ADC for an beehive weightcell.
But there is only support of the ADS1115 ADC.
Is there any chance t…
-
I am upgrading my PPT model to include the CO2 sensor. I found that using the PST config works, but only if I plug the sensors into the opposite ports.
The sensors should be plugged into these port…
-
### The problem
After upgrade to the latest 2022.1.3 all of my bme280 sensors stopped reporting temp, humidity, pressure. Before that on 2021.12.3 everything was working normally
### Which version o…
-
Since the SenseAir S8 calibration is apparently internally hardcoded to the ~2015 outdoor CO2 concentration of 400ppm, I think the package for that sensor should have an offset. The [March 2024 number…
-
Currently the ESPHome configurations use:
```yaml
api:
password: !secret api_password
```
But according to the [API Component parameter documentation](https://esphome.io/components/api.html…
-
Not sure what of the following are what in terms of features - eg. which of the below are Open Air Outdoor vs Indoor and what is the model name of each??
```
8PSL
8PSLM
8PSL-DE…
-
getCO2_Raw simply looks for a value of 254 in the first byte to check if a packet is good. Then parses bytes in the array slots 3 and 4 into a value.
A standard response from the S8 is Array[] { 0xF…
-
Device: AirGradient ONE v9
Sensor: PMS 5003
All sensors other than the PMS5003 sensor work with the [airgradient-one.yaml](https://github.com/MallocArray/airgradient_esphome/blob/main/airgradient…
-
## Do not report new issues related to this message, instead please comment on this issue with the logs that you see and the config for that component.
### The problem
```
[00:00:00][W][compone…