-
Hi there! This project was perfect for a system I was building, but unfortunately I am using the TEMPer1F_H1V1.5F and it seems to be miscalibrated. Two of them so far both seem to be reading around …
-
ets Jan 8 2013,rst cause:4, boot mode:(3,6)
wdt reset
load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
v09826c6d
~ld
tried even a file from someone else, same issue. Tr…
-
-
This is intended to track bugs found by the peripheral selftest, so that the bugs are not only found but eventually also fixed :)
- [x] Incorrect Arduino Mapping on Nucleo64 boards (see https://git…
-
$ make
mkdir -p build
cd build && cmake ..
-- The C compiler identification is GNU
-- Check for working C compiler: /usr/bin/gcc
-- Check for working C compiler: /usr/bin/gcc -- works
-- Detecting C c…
-
I've been struggling with the compilation of TEMPered and hidapi and can't find any suitable solution. I've built the hidapi 0.5.2 successfully , just needed to add the "-lpthread" to the LIBS=....
Th…
-
#### The Problem
Currently sensors and actuators are only auto-initialized when SAUL is used. This is not only inconvenient by itself, but also makes using both SAUL and the native driver API impossi…
-
Hello,
I can't build TEMPered:
$ make
mkdir -p build
cd build && cmake ..
CMake Error: The following variables are used in this project, but they are set to NOTFOUND.
Please set them or make sure th…
-
First at all: the driver is running fine on a Raspberry Pi with raspian and two TEMPerHUM attached (0C45:7402 Microdia). However, the measurements appear a bit strange. E.g. in normal conditions (arou…
-
I purchased [this](https://www.ebay.com/itm/122445696276) USB stick with an external sensor, and did not have any luck finding Linux drivers.
After a few hours I managed to hack a way to read the t…