-
As requested in [smartthings-forum](https://community.smartthings.com/t/beta-verisure-integration/95105/6) it would be sweet to implement the following;
- [ ] Change Alarm State (with pin)
- [ ] …
-
Hi,
I would really like to know how on Earth I can Request the Current Values (Voltage, Current, etc.) from my SmartPlug. In node Red the Plug is configured and working but I'm only getting real time…
-
I use a TP-Link Smartplug and the octoprint plugin. This turns off the power to my printer once the nozzle temp is below 50c and the printer has been idle for a time (30mins I think). Anyway, at this …
-
### What happened
I have a TPLink Smartplug HS110 that powers the printers as well as the Raspberry which runs Mainsail/moonraker/Klipper.
Mainsail is v2.1.1
moonraker (v0.7.1-365-g9be93ff)
Klippe…
-
Every time the uptime sensor updates (60 seconds), a line is logged to the logbook. If you have a lot of smartplugs, its a lot of entries!
-
Hi,
I own 2 HS100-EU . I bought one in 2016 and one quite recently.
I did check the firmware versions on both and the firmware do differ between both:
```
daniel@j3455:~/source/tplink-smartp…
-
Just getting to grips with the module and have managed to get it controlling some SmartPlugs pretty well, but I'm having difficulty getting devices to 'pair' with the XBee. Using your hive-smartplug-x…
-
I have a Raspberry Pi configured as a Thread Border Router and I have an Eve Smartplug (Thread over Matter).
I can only connect the Smartplug to my Thread Network via chip-tool when there is a connec…
-
Hi!
**I was able to successfully run the example code from the README without any exceptions thrown using an SP2101W V2 with firmware 3.00c.**
So, I have an Edimax SP2101W V2 and made the mistak…
-
Hi,
I'm using node-red on the emonPi made by OpenEnergyMonitor.
Today I purchased an EdiMax SP-2101W and tried to connect it to node-red.
I installed node-red-contrib-smartplug using npm, but on …