-
Daihatsu uses the n+1 across both 3 and 4 cyl.
The wiki describes daihatsu trigger as only 3+1 now.
Their 4+1 works exactly at the same +1 timing as the 3+1, its 4 pulses every 720° crank, and t…
-
This is probably getting a bit pedantic but just an observation:
My typical workflow for tuning the MX5 would be:
Key out
Connect laptop to Speeduino, start tuner studio
Turn ignition on
Chec…
-
Hello,
I have for as long as I have attempted to get the Speeduino working on my 1975 VW Bus had issues starting it. Now that the weather is colder it is basically a no go, so I decided to check th…
-
the last log I sent you it was made with the official release 202201 with a 36-1 decoder so I suppose the sync log won’t be helpful.
With your firmware or older releases I have problems making logs a…
-
I am unable to get aux inputs working as expected using the latest ini file and compiling the latest firmware (1d3a30ab4c08b146dd92ea21c55c9f138f808be8). I have also applied fix #655 and no differenc…
-
When trying to set up TS to run 3 cylinder 4 stroke semi-sequential, all injectors are firing at the same time.
Please see this forum thread for examples and case explanation:
https://speeduino.co…
-
Freely discuss your opinions on an ARM platform for Grbl, moving forward after v1.1.
-
That would be a please to have a chance to use a Mass Airflow Sensor as a Load sensor.
There is a need to have a calibration lookup curve for voltage against air mass. And then use a load_factor vs R…
-
Ch340 boards, drops comms on large burns like loading a tune or even just a full ign table.
Both cabled and bluetooth
-
There's no blitzbox in the dropdown menu of boards