-
Is there a way to compile the frame work to **ONLY** use **SVM algorithm** on **STM32F103C8T6** board?
Any instructions to install/compile this library will be encouraged.
Thanks
-
I've been looking for some real demonstration code for the STM32 processors and the CAN interface.
Thanks for providing this in an open forum.
A couple of things:
1. Best to call out the processo…
-
Hi,
Could you make the example of 3 faders midi controller on stm32f103c8t6 bluepill, because i can't find midi cc example on stm32f103c8t6.
Best regards,
-
With arduino uno and MCU_friend_KBV the screen works.
But with STM32 and your libary and example code the tft only flickers.
And the hex code is 0x5454 instead of 0x5408
Could you help me
-
Hello!
I'm trying to use https://aliexpress.ru/item/32792513237.html board.
With pre-build firmware https://github.com/cruwaller/rc_receiver_to_usb_hid/releases/download/v0.5/release_v0.5_Sim_CRSF.b…
-
I have an w5500 board that used SPI2 of STM32f103c8t6 for communication with W5500 chip. (PB12.PB13.PB14.PB15)
https://wiznetmuseum.com/portfolio-items/stm32f103c8t6-w5500-learning-board/
Please…
-
# 告别uVision——使用Keil Studio在VSCode中进行STM32的开发 | Katorly
教程懒得看？这里有配置好的项目工程文件，可以直接在vscode中打开来用：https://github.com/katorlys/STM32F103C8T6-VSCode 随着Keil MDK 6的发布，Keil Studio出现在大众…
-
Hey dear Danie
After a week of working on the project, I finally made it this far. I think it's not bad for me, who doesn't have much expertise in electronic science.
I have trouble programming the …
-
and provided URL
https://gitee.com/WeActTC/BluePill-Plus/tree/master/SDK/STM32F103C8T6/HAL/F103_ST7735
gives 404
-
i have an stm32 blue pill board , i wrote for it a simple GPIO driver , and set the upload protocol to stlink , strange enough it doesnt work properly and i was sure of the code i wrote , i tried it …