-
Just got a sungrow inverter and battery and comms module... does this work with SH10RT etc
-
Currently I am only able to stop and restart a running session. I cannot initially start a session via home assistant. The wallbox is in "EMS" mode and connected to an SH8.0RT inverter. Also when I se…
-
I'm using your Add-On for a Sungrow modbus-proxy and it works perfectly well!
Now I tried tne same on a different home assistant instance with a Huawei Sun2000 inverter. It runs into 'connection refu…
-
Can you add support for device type 3602 = SH8.0RT-20
Compare: https://github.com/mkaiser/Sungrow-SHx-Inverter-Modbus-Home-Assistant/blob/c42255c9f841b0cc275b5bcec7918687b5c6cc61/modbus_sungrow.yam…
-
Not sure what's wrong with this setup.
Maybe someone has ideas.
![Screenshot_2023-10-07-12-41-53-18_c3a231c25ed346e59462e84656a70e50.jpg](https://github.com/mkaiser/Sung…
-
Got this in the log:
Detected blocking call to sleep inside the event loop. This is causing stability issues. Please report issue to the custom integration author for sungrow doing blocking calls at …
-
Hi, apologies if this has been covered before, however, I haven't been able to find the answer searching.
My inverter is:
SG10RS with WiNet-S Dongle
I am using the Home Assistant Addon via the …
-
One of the phrases in the read-me says "All the read-only endpoints are mapped out and fully tested".
> I don't understand the *precise* distinction between what makes an endpoint read-only or writ…
-
So using the information I have used modbus master to dump the first 100 registers.
I will monitor the values throughout the day to generate a proper map. So far I can see register 24 is grid frequen…
-
If i try to install the addon in home assistant I get the following error:
`The command '/bin/ash -o pipefail -c pip install --no-cache-dir --upgrade pycryptodomex==3.11.0 -r requirements.txt' return…