-
Drop anything here that could be helpful to the development of the board. Pinouts, modules, protocols, etc.
-
Have you considered adding first party PlatformIO build support? I think it would fit very well with the project and it's aim to provide GRBL for several modern hardware stacks. I am a big fan of the …
-
Calling `sd.begin()` on a Teensy 4.1 without a card present appears to take 2 seconds before it times out and the call returns. Compare this to a Teensy 3.5 where if no card is inserted then the call …
-
Hi,
I was initially using the Arduino IDE with this library and the IDE doesn't throw any error of finding the library and installing it. But I am trying to migrate it over to platformIO on VScode…
-
blink_slow_teensy40.hex did not work with the -s option when programming the Teensy4.0. However, the soft reset works after recompiling the sketch with Arduino 1.8.13.
-
#include
SdFat sd;
File file;
char fileName[] = "datalog.csv";
#define LOGFILE "datalog.csv"
file = sd.open(fileName, FILE_WRITE);
It gives me the …
-
hi, i am trying to use smartmatrix animatedgif and im running into this compiling error... ive followed similar thread and suspect there may be multiple files causing an error.
---using teensy 4.1,…
-
I have two Teensy 4.1 boards, one used (Set A) and one newly purchased (Set B).
- Teensy 4.1 (Set A) was connected to WiFi and sending data to MQTT for nearly a few days.
- Teensy 4.1 (Set B) is …
-
Hi,
I hope you are doing well.
I am compiling for Teensy 4.1 using Arduino Version 1.8.12 and Teensyduino 1.57 , I am getting following compilation error.
Your guidance support is requeste on fo…
-
I am using the library to create a modbus-rtu slave device that has more than 50 holding registers. The master device tries to write to all the holding registers in one instruction. But the way the li…