-
Use it to measure room temperature
-
Are your K-type thermocouples connected directly to the LTC2495 or is there any signal conditioning or isolation in-between?
-
Thermocouples are needed where dissipation or environment prevent the use of NTCs, RTDs, and diodes
* use the special connectors, which are type-dependent, aim for K-type by default
* common refer…
-
I am trying to use the MAX31850 board with a thermocouple and it works, sort of works. It outputs correct room temp values but as soon as temps go high it reads very low. I know the OneWire library s…
lj502 updated
5 years ago
-
Hi I have just completed all the mods on the straight out t-962 small oven. And I am finding the left thermocouple reading twice what the right one is end even with minimum offset it reads 35 degrees …
-
I screwed up the original blue pot setting and I wonder what is the best way of calibrating oven thermocouples from scratch. I calibrated my K thermocouple thermometer in boiling water corrected to ba…
-
I've built 3 tips with thermocouples hard-soldered/brazed to the end (670C melting point): https://youtu.be/oAAN9YCJlkc
I've got a miniware D24, a generic B2 tip and a Hakko T15-D2.
Here's my "l…
-
Hi,
i got a M3 Screw style type K thermocouple and a MAX 31865, but got no clue how to wire this correctly to the SKR-3.
The manual only states that the integrated PT1000 circuit has a much lower re…
-
This can maybe be implemented with a command flag with the default being K type.
See https://github.com/PaxInstruments/t100-software/issues/3 for temperature range information.
-
In place of the graph we can have large digits displayed for one of the thermocouple readings. This is good for viewing a reading at a distance.
See https://github.com/PaxInstruments/t400-firmware/is…