-
If you have a robot, use for example, the following code while driving:
`
leftMotor.setmotor(_CCW, 0);
rightMotor.setmotor(_CCW, 0);
`
The robot will turn the left wheel off first, then…
-
Re-Reading your instructions and comparing to stm32flash helper, I was wondering why you have specified "-f" command that forces binary parsing instead the _auto-discovery_ between binary and hex form…
-
if i start printing with Cura (4.5) with Octoprint-Cura-Plugin (3.5.12) and Continuous build (bf50a18) the printer stop the print randomly.
Im using Wemos d1 mini with SD-Card shield
Any Ideas?
-
Hi, thanks for this fun project! I've just built some rev. 4 boards. And I'm testing with two WeMos D1 R2 boards and an Arduino Uno. For all boards the power supply test, interfaces test and self-test…
-
For my BPL I am using a Wemos D1 mini. I am facing the following problem. When I use a mechanical relay in the form of a wemos d1 mini shield I can only use the port D1 (tested without bpl, just a si…
-
Hi,
Is it possible to tweak the code to allow the wemos relay shield to toggle? Want to use it for a garage door controller.
-
I have 5 of the LED units working together and using your guide and code it was very simple to implement. The addition of the 'On Air' option was a great improvement.
I would like to suggest a vari…
W9TIM updated
6 months ago
-
Hi
Ethernet chips and Wemos*mini are working.
I'm wondering how interesting for you it would be to make a new Ethernet shield?
d-a-v updated
4 years ago
-
Had previously a Wemos D1 mini pro with 16mb flash and everything was working fine (using the spiffs) but as i use that board for other projects i ordered a Wemos D1 mini v3 and a SD card shield for i…
-
Needed some parts to round out the full set of equipment:
- Raspberry Pi 3 A+
- Case for RPi
- Wemos D1 Mini parts:
- 3x power shields
- 6x batteries
- Pololu Altimu10-v5 (6x)
- Adafruit…