-
Dear everyone:
I wrote my own model and my model reference point is the platform center of gravity(13.46m below horizontal), so I would like to derive the hydrostatic recovery matrix based on openfas…
-
Hi all,
I'm comparing the behavior of a floating and a bottom-fixed wind turbine in OpenFAST. However, for both the UMaine Semi-Submersible and for the Monopile, I get the same error after a short si…
-
Intuitively, a cross flow solver would also be capable of solving axial flow cases, right? Why the need of creating different libraries for each?
-
It would be good to have some FAQs about the code and other stuff
Perhaps we can start by adding questions here, and then moving them over to the Readme.md
-
Hello,
I want to use OpenFAST to simulate the load torques on the pitch motor. I'm using OpenFAST 3.5.3. To do this, I use the output parameter RootMzb1 from ElastoDyn or B1RootMzr from BeamDyn to …
-
Dear all,
I am using QBlade software for aeroelastic simulation of wind turbines and I learned that QBlade uses chrono software for its structural calculation module. Until then I have been using o…
-
Does this code could optimize a basline wind turbine blade? it only can be used to design a blade?
-
![微信图片_20230802134105](https://github.com/OpenFAST/openfast/assets/141212175/b8d6cd4a-4d61-44b6-86d0-6f01f05e907e)
![微信图片_20230802134105_1](https://github.com/OpenFAST/openfast/assets/141212175/875…
-
SWF: [c8c95623837e32efcab2067e8d5070a7ba19dbd7014ffd6612d7b21e10e07008](http://swf.codeazur.com.br/#c8c95623837e32efcab2067e8d5070a7ba19dbd7014ffd6612d7b21e10e07008) ([Direct Link](http://swf.codeazur…
-