-
The selection of the serial output is not working in the Arduino IDE. No matter what port you chose "PC" or "On Board" it seems like the build flag is not built.
I tried this on the XMC2Go, with th…
-
pins_arduino.h for XMC1400 Boot Kit has at least two errors
~~~
#define XMC_BOARD XMC1400 Boot Kit
~~~
Should be (as per other boards)
~~~
// XMC_BOARD for stringifying into serial o…
-
Is STM8S mcu like the STM8S003 supported?
-
Currently, the official arduino servo library (https://github.com/arduino-libraries/Servo) doesn't support xmc boards.
When including the Servo.h header, an error will be thrown by the compiler:
```…
-
This bug is referenced in #68
Basically if analogWriteResolution has been set to anything other 8 bits in main parts of code, incorrect values will be sent to analogWrite, reducing range of duty cy…
-
As shown in the attached image:
![XMC 2Go_PO](https://user-images.githubusercontent.com/37465483/60880637-aaa55480-a261-11e9-9758-43dc9dc6ded6.jpg)
the UART Rx and Tx pin mentioned are P2.6 and P…
-
I've tried both cartesian and spherical sketches and the same readings are printed regardless of how far or the orientation of the magnet.
Readings:
`Amount = 0.17 mT; Azimuth angle (rad) = -2.36 …
-
-
http://www.infineon.com/cms/en/product/microcontroller/32-bit-industrial-microcontroller-based-on-arm-registered-cortex-registered-m/xmc-development-tools-kits-and-boards/channel.html?channel=db3a3043…
-
@techpaul
This is an issue I start reporting at #79 but since it was not the correct place I am starting this new thread with more proof of an issue with XMC device.
The problem is basically that…