-
hey,
just flashed the "HyperSerialPico_sk6812Cold.uf2" onto a Raspberry Pi Pico,
a "Reset" Device appeared after the Flash in the Device Manager under "other"
![grafik](https://github.com/awa…
-
Ein schönen guten Abend an den (die) Entwickler von WLED,
Da ich im Hyperion Forum gelesen habe das WLED die Adalight Ausgabe beherscht, wollte ich das ganze mal mit Ambibox ausprobieren. Da Ambibo…
-
**Describe the bug**
Version 8.3.7 shows up as 8.3.6
**Simhub version**
8.3.7
**To Reproduce**
Steps to reproduce the behavior:
Bottom left statusbar shows wrong version, logfile shows wrong…
-
I understand that you have Pi support and are not really interested in adding Arduino support as it's a little difficult due to all the different LED strips. I use a program called Primatik to run my …
-
### Discussed in https://github.com/awawa-dev/HyperSerialESP32/discussions/32
Originally posted by **myswa87** March 30, 2023
Hello Awawa,
I find it very challeging to get two correctly wor…
-
**Describe Your Problem:**
I'm having a problem with a relatively simple (3 devices) setup. I'm using Hoobs and have installed wled-ws on its own separate bridge. It seems to startup connect to t…
-
As well as the TPM2.NET feature, would it also be possible to include the Glediator serial option?
The code as a stand-alone that works well for me is really quite simple.
```
#define FASTLED_E…
-
Heya,
Apologies if this is the incorrect place to send over this query. I've just swapped out my ESP-WROOM-32E for an ESP-WROOM-32 assuming I could get the baud rate of '2000000'. On the first boot…
-
Hello! Thanks for a great project! :)
I'm trying to make it work on my rooted lg tv using esp32 dev kit with CH9102F usb2uart chip, which is supported natively by tv os.
But it doesn't work some how…
-
### What happened?
On a ESP32 based board without USB IC WLED software stops working almost immediately when RX pin (GPIO03) is not pulled down (and USB IC is not attached). After power-on WLED start…