-
# Core Objective
To establish a rich set of quality .NET bindings making it straightforward to use .NET and IoT devices, there needs to be a rich offering of supporting tooling. And while it will …
-
### Creating a bug report/issue
#### Required Information
- DietPi version | `
G_DIETPI_VERSION_CORE=6
G_DIETPI_VERSION_SUB=34
G_DIETPI_VERSION_RC=3
G_GITBRANCH='master'
G_GITOWNER='MichaIng'…
-
I've tried multiple times with no luck:
pi@duet3:~ $ sudo chmod 755 RRF_STM_3_2.sh
pi@duet3:~ $ ./RRF_STM_3_2.sh
-----This will install the STM Version of DSF-----
-----Update and upgrade the PI--…
-
For each SPI bus (up to 6 on the Raspi4), there are 2 or 3 designated pins for Chip Select (CS)*. The underlying hardware driver normally expects that one of these is also used. For SPI0, pins 7 and 8…
-
Debmatic lief über einen längeren Zeitraum problemlos auf einem RPI4.
Nach einem apt-get update && apt-get upgrade kommt es nun zu Problemen/Fehlermeldungen.
"dpkg-divert: error: error checking '/…
-
Wie bereits geschildert, werden die Werte bei Rasbian Buster nicht ausgelesen.
Als Workaround habe ich die Distribution Jessie installiert. Dort funktioniert alles.
In der Sensorkal.py und water…
-
The last line of the log in /var/log is this:
Removing 'diversion of /boot/overlays/spi4-1cs.dtbo to /usr/share/rpikernelhack/overlays/spi4-1cs.dtbo by rpikernelhack'
Here's the full log:
…
-
Hello
I cannot understand how to use characteristic change. For example
How can I change it by change on current sensor (or temp sensor) with MCP3008
I found nodejs files to work with MCP3008
But…
-
Line 22 of the [MCSP3008 driver](https://github.com/raspberrypi-aa/raspberrypi-aa/blob/master/spi_hardware_test.py#L22) has an error.
The code at line 22 says `return [startBit, singleEnded|(channe…
-
Hi,
As the title say I've a Raspberry Pi4 and a respeaker 2mic, I installed the driver apparently with success then rebooted as suggested.
The Pi show briefly a rainbow screen then goes black and st…