-
Dear Marcus,
I'm a newbie in the Milight world, and I'm wondering if this node can be used to programmatically link my Milight light bulbs to a specified zone?
**Current setup without NodeJs**
…
-
There seems to be less documentation for the mini board than the others; I can't get it to work (OV 5642). I get just garbage back to the serial monitor. Also, since there's no SD port on the mini shi…
-
So I've done a move for most of my lights from my hue bridge over to my conbee + deconz on x86. 7 hue lights with the latest firmware, 1 osram rgbw led strip and one Ikea tunable white gu10 and one Ik…
-
Dear Chris,
I can reproduce an issue : after a cold start, or after several minutes, i cannot control my Milight RGBW bulbs. (as same as Domoticz and Bridge WebUI)
However, when I send a command t…
-
Hi,
Nice design. Maybe I'd like to make a similar kind of board for the Particle Photon. I was wondering why you have selected the ADM2582 and not the ADM2587. From what I can see in the datasheet th…
-
I have remote FUT098 for controller for RGB LED strips - http://futlight.com/productdetails.aspx?id=175&typeid=143
Where i can put config for it (i sniff SPI analizer) ?
SYNC_WORD
![image](https:/…
-
RGB and RGBW support is needed. Somthing like this may help?
There seem to bee alot of HSB(HSV) to RGB converters out there. Maby this can help:
https://gist.github.com/eyecatchup/9536706
-
Raised by @lstt2005 in #14. The protocol has some minor differences from the one used by the RGB+CCT remotes:
1. `b[1]` is 0x21 instead of 0x20. I'm assuming that b[1] indicates remote type or some…
sidoh updated
7 years ago
-
Looking at the LimitlessLED strip controllers page, there's a new one (as of 2016) that says it'll run both the RGB chips _and_ the white chips at the same time, giving us saturation control.
Do you …
-
Is it possible to add support for the new wifi bridges? I just bought one and would like to use it with this library. The specs have been published here: http://www.limitlessled.com/dev/