-
Hello. I'm trying to use the output data from the Delft3D modeling software. However, as the grid that delft3d uses is curvilinear, I need to extract the data and interpolate in a regular grid so that…
-
Good evening,
I am given a .nc file with the following available time:
The OceanDri…
-
Dear all,
I use OpenDrift (v 1.3.3) to study movement of particles in the Caspian Sea. In the Opendrift.run I get the following output: _Moving 100 out of 100 points from land to water; WARNING: No …
-
I use two polygons to seed in leeway, the points are as follows:
(1)polygon 1
lon_input=[115.5, 115.5, 116.5, 116.5, 116]
lat_input=[21.5, 22.5, 22.5, 21.5, 21]
(2)polygon 2
lon_input=[115.5…
-
Dear Knut-Frode,
I faced a problem of incorrect vertical levels reading from .nc file.
data.nc provides 25 sigma - levels, but both reader_netCDF_CF_generic and reader_netCDF_CF_unstructured see on…
-
HI, I have some questions
1. Run openoil model I seed 3000 particles within a radius of 50 meters, why there are a lot of green particles out of the initial position I set. (see figure 1)
2. Why …
-
Hello;
I am trying to see particles at the bottom of my domaing using z='seaflor', however I am using a ROMS forcing and I do not have sea_floor_depth_below_sea_level in my input file. So, followin…
-
Hello, my name is Arian Dialectaquiz and I'm I am an undergraduate student in the laboratory I am a part of (Laboratory of Coastal Hydrodynamics of the University of São Paulo - LHiCo -USP), and yeste…
-
HELP on SEDIMENT SIMULATIONS
-
Hi, while I was performing some tasks I found an error
00:23:50 INFO: Exception:
00:23:50 INFO: 'mask_rho'
00:23:50 DEBUG: Traceback (most recent call last):
which doesn't find the file that cont…