-
I have a problem with the Shelly 2 module. I have the current Tasmota 6.3.0, if I select Shelly2 in the settings it's catastrophic, it comes to constant misconnections, although I don't press the swit…
-
Can you provide a definitive GPIOS list for Template since there are still some missing in the console command.
-
Hi,
I do have permanent MQTT Disconnects/Connects in my mosquitto MQTT Broker log:
`1549537348: New client connected from 192.168.1.XXX as S20Steckdose5 (c1, k10, u'DVES_USER').
1549537348: New c…
-
I've just flashed my Shelly2 with Tasmota 6.2.1.5 and connected a 60 W bulb with an external power meter for calibration.
I have run the VoltageSet, CurrentSet, and PowerSet commands with the value…
h-tro updated
6 years ago
-
I have successfully been able to flash this device with Tasmota. I tried to choose the Tasmota “generic” device but I couldn’t figure out how to configure it. Anyone?
-
After flash standard FrequencySet is 0 -> Tasmota shows 51 Hz.
My meter shows 50 Hz.
I set FrequencySet 50 -> weblog shows FrequencySet 500 -> Tasmota shows 66 Hz.
I set back to 0 or another value,…
h-tro updated
6 years ago
-
It happens randomly but within 20-60 Minutes regularly. Is not a hardware issue as it happens on several units.
WLAN deauth and associated / authorized is between 1 Second and several minutes.
It …
-
Activating the KNX protocol (great feature!) I found that on Sonof I could select buttons, but on my Shelly1 I could not. The reason turned out that Shelly is configured with GPIO_SWT1_NP instead of G…
-
The Shelly1 and Shelly2 require pinMode(INPUT) for their switch terminals. Tasmota automatically sets pinMode to INPUT_PULLUP when configured.
I have edited the sonoff.ino file to remove INPUT_PUL…
-
I am using the Shelly 1 and uploaded the latest sonoff.bin from thehackbox (compiled 20181006 11:02 GMT+2). I found out that switchmode 1/2 work fine and trigger the relay directly, 3/4 do not seem to…