-
**Describe the bug**
- Partway into the ride, either SS2k stops updating resistance or it's not updating enough to cause the stepper motor to turn.
- Gear +/- buttons in QZ don't have any impact…
-
### Description
### Steps to reproduce
1. Try to use the Z probe offset adjustment in the touch screen menu.
**Expected behavior**
The nozzle moves up and down so you can use the pap…
-
**Describe the bug**
Hello there I was trying to test the example with the TMC2208 but not able to start the stepper motor.
But a simple gpio control works
The delay between the the high and …
-
### Description
When I boot up my SKR 1.3 Controller with the TFT35 V2.0 Screen (Touch-Mode) my Z-AXIS always moves up "some" height. It's definetely more than 10 or 20, feels like it's traveling the…
-
I have a MKS SGEN_L V1.0, MKS TMC2208 in UART mode, running Marlin 2.0.7.2, 3Dprobe, BTT TFT35E3V3.0 touchscreen, with firmware version TFT35_E3_V3.0.26x Jan 29 2021 and get a pop up message on start…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I want to configure Marlin Fw without Extruder. Following [Issue #10212]( https://github.com/…
opmtk updated
4 months ago
-
I'v got an BIGTREETECH SKR 1.4 Turbo connected to the TFT 35 V2 using the RS232 Port on the TFT and the TFT port on the board. Updated the screens firmware, set the baudrate @ 250000 on both Marlin (o…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Tmc2208 standalone drivers do not allow for linear advanced control.
### Bug Timeline
_No …
-
installed catboat via KIAUH, built firmware using the following params:
printer beeps 5…
-
Hello does anyone know whether the ender 3 v2 with 4.2.2 board is compatible with a BTT tft50 display?