-
Grbl_ESP32 Ver 1.1f Date 20200319
I am using an ESPDuino, CNC Shield and ESP32_Grbl successfully with an MPCNC, Grblgru and 4 axes. Both USB and BT work well.
I soldered wires to the ESPDuino pins 1…
-
As the title says - Vsb (power provided from the Nice motor) is not always 24V DC.
I have a Nice Road 400 with RBA4R10 control unit and I have measured 34V between the Vsb and GND pins.
This would…
-
Hi o/
I have a Wemos D1 and Im having a problem with the code compilation.
It says that `MCP_ANY` wasnt declared in the code and that i should replace it with `MCP_CAN`.
Im not very familliar wit…
-
Hey,
And thanks for the project.
Before buying a WeMos-TIC shield, I was asking myself : what is the power consumption of the ESP32 with the WeMos-TIC board and the project running?
Would it be suitab…
-
### The problem
Not available the Dallas sensors after uprade to ESPHOME v2022.3
### Which version of ESPHome has the issue?
2022.3
### What type of installation are you using?
Home Assistant Add…
-
Ik ben aan het migreren van Domoticz naar DSMR-Reader voor inzicht in mijn energieverbruik. Allereerst grote complimenten voor deze software!
### Mijn setup is als volgt:
- WemosD1 met P1 shield h…
-
### What happened?
When I un-check "Disable realtime gamma correction" under the Artnet settings, WLED will no longer boot and I have to wipe my esp8266 to get it to work again.
It doesn't matter …
-
http://forum.mysensors.org/topic/3285/solved-esp8266-fails-to-boot-with-nrf24l01-connected/5
## From @Daanoz debugging:
Ok, after debugging for a while: the problem is with the CSN pin on GPIO pin 15…
-
Hi,
We have an old boiler that does not support the OpenTherm protocol, but is just an on/off one. Can we still use this on a Wemos D1 mini and connect the 2 boiler wires to the rx/tx on the shield…
-
Has anyone created a gerber file for this project? I love the project and I'm using it for 433 MHz devices to HA, but thinking to move away from breadboard and cables into a PCB and a box. I would app…