-
I think this is a glitch in the intellicode, confused me initially when tuning the heaters and so on.
-
Does not recognize G-code on duet 2 wifi/ethernet web interface. firmware 2.03.
-
I have thinking a lot about this I2S to a shift register. The time resolution should be good and look at this driver for RGB displays:
https://github.com/mrfaptastic/ESP32-RGB64x32MatrixPanel-I2S-DMA…
-
I've setup the custom firmware with my MKS TFT Wifi (ESP-12S). The web UI shows up nicely, but I can't get it to interact with the board. The baudrate is the same (115200) and it's using data port 808…
-
Hello,
it is possible to control the Tronxy firmware V1.4.1RC24m4 with the TronxyX5SA board https://de.aliexpress.com/i/32920995172.html with the original firmware and an ESP8266 module.
I have the…
-
after upgrading to RepRapFirmware 3.01-RC9 from RC8 the thermostatically controlled fan does not turn on at the set temp. (As this is the hot end fan this caused a huge clog in the printer) The JSON s…
-
Hi. I have an SKR 1.4 configured with the great Reprap firmware.
Similarly to my Duet wifi I configured a dual Z axis to have independent Z axis compensation with a BLtouch.
I have assigned it the f…
-
I just installed the ESP3D on a NodeMCU board. It seems to be working. I tried uploading a file into the printer (no printer attached, just a blind test, the printer serial interface set to 250kbits p…
-
I'm trying to set up a reverse proxy for this. In the past, the asset links were relative, but now they seem to be absolute. Is there a way to set up a reverse proxy on a given path? e.g. https://aequ…
-
I'm assuming instances of `com.apple.CrashReporter.plist` in isolation isn't something to be too concerned about (using `mtv-project` and `pegasus.stix2` indicators). Is it worth highlighting this in …