-
Follup to #613
There are SD card corruption issues. All over the smoothie codebase are hacks or warnings to keep files only open for a short time to avoid those. The goal is to get rid of those and …
minad updated
7 years ago
-
Are others interested in GRBL code , 11 Axis max (U-E) that
have gcode and motion_control on PC side and on uC replaced by fifo module.
I want doing that for testing advanced spline or ramping algor…
cri-s updated
8 years ago
-
In the developer documentation, could you add a brief overview of the folders in the machinekit source? For example, I was looking at the source to find the code for the GCode interpreter as shown in …
-
In my gcode sender, I have an editor where I can select lines and have those lines highlighted in a visualizer. Internally I do this by generating a simple CSV intermediate file: "original line, proce…
-
I've built a drawbot that uses DC motors from very old CD drives. They are NOT steppers, just simple DC motors with an H-bridge. I modified the very basic interpreter from this project[1] so that it d…
-
I have been using GRBL with L6474 driver boards ( Arduino pin-out ) , which require some additional set-up parameters since they are a lot more configurable than the typical STEP/DIR boards commonly u…
-
The Gcode circle/arc command G2 is not executing, yet G3 is. This command will execute: G3X4Y4I0J2F60 It goes counterclockwise in what appears to be a 4 inch diameter circle.
This same command: G2X4Y…
-
```
I need someone to help me to determine an arc's axis (gp_Ax2 or similar)
given two endpoints and a centre point. This is easy enough when the axis
is straight up the Z axis but I can't figure it …
-
```
I need someone to help me to determine an arc's axis (gp_Ax2 or similar)
given two endpoints and a centre point. This is easy enough when the axis
is straight up the Z axis but I can't figure it …
-
```
I need someone to help me to determine an arc's axis (gp_Ax2 or similar)
given two endpoints and a centre point. This is easy enough when the axis
is straight up the Z axis but I can't figure it …