-
Hi,
I tried to install either by USB,SD card, and SSH but no success to report
1. I inserted the USB stick with the driver (venus-data.tar.gz) and the DALY RS485 cable (other end in the bms) US…
-
Hello, I installed the code as described. Immediately after running the install.sh script, all values in Venus (such as Grid, Critical Loads etc.) were set to zero - causing a battery alarm. So I quic…
-
**Describe the bug**
When I reboot the GX device (RBpi) Node Red does not find the source which I chose in the node. I need to reconnect manually all node in node red. It is odd, as the name is exact…
-
Hi Manuel
It's me again. I managed to publish the necessary data via Node-Red to the topic: enphase/battery.
![Screenshot (124)](https://user-images.githubusercontent.com/115894307/230320852-641…
-
Hello,
I was looking for a possibility to use nodered with a victron solar charger without an additional VenusOS Raspi.
Your solution would be a easy workaround, I thought.
The problem is I have …
-
My apologies if this has been covered elsewhere. I searched but didn't find anything.
**Describe the bug**
If the cerbo is reboot for any reason, often times the bms gets assigned a different instan…
-
I recently got this running with a ds18b20 sensor.
Fantastic and simple when you know how.
I went further by removing my probe and adding three sensor together with a 4.7k resistor between the p…
-
I would like to have a CV discharge behaviour - i.e. if I set a mimium Voltage of e.g. 3.0V/cell, then the multi should draw as much current as is possible so that the cell voltage does not get below …
-
What do you think about adding support for the 1EM shelly?
(I have a micro-inverter on the AC out on my Multiplus 2, connected via an 1EM shelly, and it would be quite cool to integrate it into my …
-
Quite a new and happy user here. Thank you for making VenusOS and the use of MQTT available to the Community!
I couldn't help but notice, that in the +1000 topics available only a few (less than 10…