-
- [x] I confirm that this is an issue rather than a question.
## Bug report
After controller being turned off/on Hyperion does not reconnect to WLED through adalight. WLED acts…
-
### What happened?
When I try to use the serial interface to get data/control WLED, I get output when it boots up (see below), but when I try and send commands (e.g. `v` or `l` or `L`) I get no reply…
-
### The problem
I have 5 different Raspberry Pis running Hyperion (latest, installed per Hyperion documentation for RPi). Each one of them exhibit the same problems that render them effectively unusa…
-
After starting Prismatik "turn off lights" function works like a charm, but after some time, when I want to turn LEDs off I need to press Prismatik icon few times.
Prismatik creates strings in log fi…
-
**Describe the problem you have/What new integration you would like**
I want to be able to create custom addressable effects so that they can be:
- shared between different lights
- packaged …
-
# Problem
When the luna-command to the `/start` endpoint is sent too early after bootup (e.g. by executing it as part of init.d/ scripts), startup of the hyperiond service fails with the error resp…
-
Awesome integration. Thank you for this!
When I change a color in HA it stays on my screen for 60 seconds and then the LEDs go dark.
The profile is still saying `hass` so it's still locked, …
-
Hi there,
is it possible to somehow turn off the Arduino's power and RX LEDs by software or would that have to be done by either turning it off in the Adalight sketch or removing the LED from the Ard…
-
Hi,
I flashed HyperSerialWLED ony my 340G AZ Delivery D1 mini v3. It is working good as WLED and also with HyperHDR over network. However, when I connect it to the Pi through USB and enable adaligh…
-
- [x] I confirm that this is an issue rather than a question.
## Bug report
I have manjaro OS + arduino
sketch has been added to adruino successfully (/dev/ttyUSB0)
but webUI…