-
Hello, i'm having An issue when i upload Marlin 2 to my Skr2.0 revB with 2209 stepper drivers. Printer is a tronxy x5s corexy model. I can move all Axis, however X and Y only move diagonally. Corexy …
-
### Bug Description
In the configuration section of the Bltouch installation wiki, it is possible to run into the situation where you cannot lower the nozzle any further so that the paper becom…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
bugfix-2.0.x Does not compile with Ender 6 (Creality) config files (Configuration_adv.h, Conf…
-
### Bug Description
Just after cloning i can not compile the MEGA_S_DGUS using the project.
### My Configurations
Nothing specific, everything by default.
### Steps to Reproduce
1. …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Could not get code to compile using modified configs, so I attempted to use the example confi…
D337z updated
3 years ago
-
### Bug Description
I have a Mega X with blue-yellow lcd, middle picture here:
https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/Types-of-Anycubic-Touchscreens
Knutwurst fw i…
-
hey
i have a problem my extrudere does not turn wen i tell it to i have checked the wires with a multiemeter. but if i use the menu and try loading the filament it does not turn for some reason fir…
-
Hello i have a anycubic mega x with bltouch
if i send a g29 command from octoprint it probes ones and the it stops i use MEGA_X_DGUS_TMC_BLT_10_v1.2.0-beta.1.hex firmware it gives me this error WA…
-
Printer: Anycubic-i3-MEGA-S
Release: 1.1.9
### Bug Description
After removing the filament, no change in nozzle temperature is displayed (E0 Temp). Restarting the printer corrects the problem. …
-
### Bug Description
Trouble finding wiki info - bltouch wiki page says i have to use correct version ( 10, 11 ) but there is no info on how you actually find out the version on the wiki, i have a i…