-
TMC2208 X connection... Error: All LOW
But same Stepper will work in Y,Z or E. So Stepper ok.
X will work with TMC2130 in SPI mode or TMC in Standalone mode. Think it may be the X-UART jumper pi…
-
When trying to compile after including the fastled library, the following error is shown:
"This platform isn't recognized by FastLED... yet. See comments in FastLED/led_sysdefs.h for options."
Th…
-
I've installed 2021.10-004 and 2021.10-003 to SPI and booted them from SD and USB (with SPI erased, eMMC disabled via the switch, and no other bootable devices present). In all cases I get a red power…
-
Hello.
i don't know much about linux...
i have an e173 3g dongle and im trying to get it to work on a raspberry pi 1 b+.
i installed rpi-source from [here](https://github.com/notro/rpi-source/) im …
-
This is issue is opened to discuss the tab structure.
### Proposal
| Week No. | Lab | Lecture |
|------:|---------|-----|
| 1 | Introduction to Rust (this is the lab before the class) | Introd…
-
Using RE to boot Tow-boot installer from SD because prw+vol.dn failed. This is the serial output.
-------
Tow-Boot TPL 2022.07
Channel 0: LPDDR4, 50MHz
BW=32 Col=10 Bk=8 CS0 Row…
-
https://www.st.com/resource/en/datasheet/stm32f446re.pdf
https://www.st.com/resource/en/user_manual/dm00105823-stm32-nucleo-64-boards-mb1136-stmicroelectronics.pdf
https://www.st.com/resource/en/appli…
-
CPU: Allwinner H5, Quad-core 64-bit high-performance Cortex A53
DDR3 RAM: 512MB
Connectivity: 10/100/1000M Ethernet, RTL8211E-VB-CG chip
USB Host: USB Type A x 1 and USB pin header x 2
MicroSD Slo…
-
Hello,
I'm currently looking into this project, and it seems very intresting, however i'd like to have RFID LF support (especially for reading animal chips that are 134.2khz). I'm currently looking…
-