-
提供されているサンプルコード https://r.chirimen.org/examples と同等のコードをESモジュール化したものに変更し本リポジトリ [/examples](http://chirimen.org/chirimen-drivers/examples/) に加える
CHIRIMEN上のブラウザーで動作確認を行う
- [x] @chirimen/ads1015@1.0…
-
Hello,
I am not sure if my title makes sense, I ll try and explain it here.
Say I have a function of the form funcA( custom_type_t* member, char* param1, char* param2)
in a moduleA. Here the retur…
-
_NOTE: I am [reposting my forum post](https://forum.beagleboard.org/t/l2-cache-flushing-due-to-starfive-7100-architecture/29197) here for greater visibility._
The BeagleV beta boards have the StarF…
-
**Description**
I compiled the kernel with Rust support and tried to boot. However, I am stuck at the emergency shell.
From what I can see in logs, it seems that the modules fail to load. Might be r…
-
When will this be possible? The current adc example only reads ref/gnd and the library has no access to the 4th input. I am looking to use my analog co2 sensor with this.
-
Hi,
When I try to add the Ph-board driver, i have this error.
write /dev/i2c-1: remote I/O error
Everything seem fine:
![image](https://user-images.githubusercontent.com/6782832/81503392-aadc0…
-
Hello, me again! :)
Sorry for disturbing but it seems to be difficult for me to figure out how how to configure SensESP for reading multiple analog inputs/sensors.
As far as I understand the easi…
-
- Arduino board: ESP32-DevKit3
- Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.10
- List the steps to reproduce the problem below (if possible attach a sketch or
copy th…
-
In the following file:
https://github.com/adafruit/Adafruit_ADS1X15/blob/master/Adafruit_ADS1015.cpp
Line 72 is as follows:
@brief Writes 16-bits to the specified destination register
Should be som…
-
According to the ADS1115 datasheet, the maximum sample rate for the ADS1115 is 860 SPS. However, there is no way to change the sample rate in your code, and the default is set to 1600 SPS, as noted in…