-
Hey! I'm considering using your bootloader in a project, but there is no license attached, meaning it cannot be used currently. Would you care to attach a license to the code? If you're unsure what to…
-
### Bug Description
This is `bugfix-2.0.x` commit d84aff701e10a49d5ccc69ce323fdb0fdb84b6db
Long travels exhibit stuttering movement when ABL is configured and enabled.
If I switch ABL off by …
-
**Is your feature request related to a problem? Please describe.**
A clear and concise description of what the problem is. Ex. I'm always frustrated when [...]
**Describe the solution you'd like**…
-
I setup timelapse + mainsail. The frame is triggered on layer change as expected but the tool head first moves to the rear-right position before moving to the custom position (or the preset one like …
-
Hi,
I use Cura to print to make toolpaths for a custom printer that uses material approximately 22 mm in diameter, thus extrusion speeds are much slower than with 2.85 mm filament.
The issue is …
-
I have recently installed the smart filament sensor on my ender 3 pro runnin an skr mini e3 v2.
I have host commands enabled in my firmware so when the printer sends the m600 command when the sensor…
-
Can an option be added (check box) to disable bridging or set a minimum "unsupported area" threshold? The slicer adds bridging where it is not needed and this can cause issues.
The slicer also adds …
-
### Description of the bug
With 3 extruders enabled;
The lowest numbered extruder printers first (1) with a temperature selection for other layers set to 250;
No tool changes between layer 0 and …
-
Hi,
After upgrading to v01-1.2.5, I've experimented a very strange bug with my Sigma R16.
Sometime, **during a print**, the "unload filament" procedure seem to start for no reason.
The extruder…
-
### Version
1.41.1 windows
### Operating system type + version
Windows 10
### Behavior
Setting a negative value to "extra lenght on restart" generate holes in solid surfaces/infills
* Set a …