-
Parameter to know if firmware upgrade over the air is supported
homie/super-car/$fw/upgrade-supported → "true"
-
## Tasks for release of v3.0.
[ ] Clean up branches
[ ] Talk about final additions for v3.0
[ ] Review and clean up formatting.
Anything else? Lets talk.
@ThomDietrich @bodiroga @bertmelis @i…
-
I installed all libraries according to the 'getting started' and they show up in my 1.8.3 arduino IDE. I'm using a wemos d1 mini which works when I load the 'blink'.
But when i try to compile the 'ba…
-
Hi guys,
I'm 1-2 days user of Homie and I like it very much! I faced some difficulties I want to suggest some features that would be useful to everyone:
1) homie//$implementation/reboot - for ea…
-
Hey!
I'm using ranged properties (as per your SDK for homie on esp8266).
`zoneNode.advertiseRange("on", 1, 3).settable(zoneOnHandler);`
What would be the standard message to MQTT to send rang…
-
Hi,
is it possible to switch the status led off?
It seems there is every X seconds a short blue blink.
I have a Wemos D1 in bedroom, and even though the LED is so small, it's much too bright for …
-
Hi ,
Am pretty new to home automation and ws8266. I have setup the following
WS2812B based LED strip and has 60 LEDs
NodeMCU with WS8266
I have connected the 5v 4amp power supply to volt(red …
-
Hi!
I am new to Homie and Platformio. I read the documents and what I do for adding the `config.json` file is running:
- `platformio run --target uploadfs`
- `platformio run --target upload`
I…
-
Hello everyone. I am new with homie. I flashed basic code and flashed ui_bundle.gz to data/homie folder my esp8266. But in iPhone and Mac captive portal not loading. Here is the screenshoots.
W…
-
Hi,
I'm testing it with a nodeMCU 0.9, I got the following log:
Boot in config mode, ok. Then I send json config and :
```
Received config request
✔ Configured
ets Jan 8 2013,rst cause:2, boot …