-
im using nixos nixos-unstable@916ee862e87 and nixpkgs-wayland overlay @ https://github.com/colemickens/nixpkgs-wayland/tree/fff3832d082ccc20447173fc8d75aebff94469ec
when i run sway the screen stays…
-
I am using ESP32 and HX1230 SPI LCD with struct
`U8G2_HX1230_96X68_F_3W_SW_SPI u8g2(U8G2_R0, /* clock=*/ 14, /* data=*/ 13, /* cs=*/ 15, /* reset=*/ 26);`
At the same time, I am using CSD30 I2C C…
-
Hi guys! I was using your excellent library to run up my SCD30 on ESP32 with Amazon FreeRTOS. I found a few little gotchas that I thought I'd mention.
Firstly, I was getting a full on kernel panic…
-
I have a new SCD30 sensor which works good in the web interface of Tasmota but sending the information to domoticz goes wrong.
"Sensor idx 9 AirQuality" is working but "Sensor idx 2 Temp,Hum" NOT.
`…
-
According to the [interface description](https://www.sensirion.com/fileadmin/user_upload/customers/sensirion/Dokumente/9.5_CO2/Sensirion_CO2_Sensors_SCD30_Interface_Description.pdf) Section 1.3.1, the…
-
Hi,
I have some problems with your SPS30 sensor with the TI CC3220MODASF MCU.
Using your SDK (sps30_get_serial), and when I read the serial number, I only get "FF" bytes and the CRC check fails.
ca…
FATRI updated
5 years ago
-
The Power/Volume buttons worked perfectly with kernel version 5.9.13, but stopped working after the upgrade to 5.10.1
After updating the kernel from `5.9.13-surface` to `5.10.1-surface` via…
-
Doing the steps in https://raspberrypi.stackexchange.com/questions/37796/how-to-use-i2c-gpio-with-raspberry-pi I still cannot detect the SCD30 using 'sudo i2cdetect -y 1' / 'sudo i2cdetect -y 3' . Do …
-
Hello and thank you for this great library!
I am using it with an ESP32 over UART and have a weird problem. After starting the measurement mode, it only takes some measurements (between 1 and 10) and…
-
Modifying name to be `name=SparkFun_SCD30_Arduino_Library` would allow this library to be usable as-is in particle.io.
CIPop updated
5 years ago