-
Vision: I would like to create a new XBee/Zigbee binding for openhab.
Problem: Currently I have a simple magnetic reed switches for detecting when my garage door is open or closed. A Xbee remote is…
-
```
General ZWave Support
Implement binding for ZWave Controller/Device/Network support.
```
Original issue reported on code.google.com by `bmcro...@gmail.com` on 29 Apr 2013 at 12:25
-
```
With the (upcoming) release of 1.3.0, it's time to think about and work on the
next version of the Z-Wave binding. We like this as much to be a collaborative
effort as the previous version was.
…
-
```
General ZWave Support
Implement binding for ZWave Controller/Device/Network support.
```
Original issue reported on code.google.com by `bmcro...@gmail.com` on 29 Apr 2013 at 12:25
-
```
With the (upcoming) release of 1.3.0, it's time to think about and work on the
next version of the Z-Wave binding. We like this as much to be a collaborative
effort as the previous version was.
…
-
On every lauch of openHAB all KNX binding commands will be activated once, so all my lights will be switch on or off, dependent on current status. After the launch, everything works fine.
I work with…
-
```
General ZWave Support
Implement binding for ZWave Controller/Device/Network support.
```
Original issue reported on code.google.com by `bmcro...@gmail.com` on 29 Apr 2013 at 12:25
-
```
With the (upcoming) release of 1.3.0, it's time to think about and work on the
next version of the Z-Wave binding. We like this as much to be a collaborative
effort as the previous version was.
…
-
```
General ZWave Support
Implement binding for ZWave Controller/Device/Network support.
```
Original issue reported on code.google.com by `bmcro...@gmail.com` on 29 Apr 2013 at 12:25
-
Hey,
I have a strange issue with two Openhab + Zwave setups where the zwave networks crashes after around 1 - 42 hours. These setups are independent but showing the same behavior. The zwave log prin…