-
```yaml
{
"id": 39,
"title": "RVD#39: Remote Firmware Upgrade in Alpha 1S As",
"type": "vulnerability",
"description": "It is possible to remotely upgrade the Alpha 1S firmware by send…
-
I cannot receive when transmitter is attached(neither can the real kaku). Neither does sending seem te work. I can receive codes if only the receiver is attached.
What could be the problem?
If …
-
Hello saramonteiro,
Hope you are doing great. I need some information regarding your project like which Lora module you used and its frequency. I am using ESP32 Devkit V1 and Lora RA-02 modules. Is …
-
LoRaSimpleGateway.ino Is unstable out of the box
I've Just changed this in LoRaSimpleGateway.ino
```
const long frequency = 433E6; // LoRa Frequency
const int csPin = 5; // LoRa radio…
-
After setting up an enviro weather board with the 0.0.9 firmware, powered over USB, I repeated had problems with it stopping sending MQTT message after a few hours. The exact time seemed to vary each …
-
### Description
Bonjour, je propose que ceux qui le souhaitent laisser leurs coordonnées afin de se rencontrer...
on peut être voisin sans le savoir... et on peut s'échanger des idées... Tous ensem…
-
Hello,
I try to receive data from a "TFA Dostmann 30.3249.02" (thermo/hygrometer).
The payload is similar to the [TFA 30.3221.02 protocol](https://github.com/RFD-FHEM/RFFHEM/blob/a1222ecd68e1febeca8…
-
```
What steps will reproduce the problem?
Use a Bye Bye Standby 2011 remote to send a key press to my 433Mhz receiver,
which is connected to an Arduino on a PC.
What is the expected output? What do…
-
```
What steps will reproduce the problem?
Use a Bye Bye Standby 2011 remote to send a key press to my 433Mhz receiver,
which is connected to an Arduino on a PC.
What is the expected output? What do…
-
# Motivation ⛰️
> On the COMMS PCB we will be using CC1120 transceivers, so this project will involve configuring the transceivers so that we can communicate with the satellite.
# Next Steps 🚶…