-
### Describe the bug
rpi-eeprom-update doesn't list the latest VL805 firmware update until after it has been installed.
```
root@pi-taucha:~# rpi-eeprom-update
*** UPDATE AVAILABLE ***
BOOTLOA…
-
I’m doing a project using a bare Attiny85 and an I2C Time of flight sensor (VL6180x).
The module has 10k pullups on the SDA and SCL lines, but I also added 10k resistors externally on the SDA and …
-
### Description
When using the CAN bus under EPS32, the target is not supported error.
System Information
HAL build info: nanoCLR running @ ESP32 built with ESP-IDF ac5d805
Target: ESP32_B…
-
Hallo zusammen!
Habe einen Sketch erweitert und ihr könnt ihn gerne auf der Homepage verwenden. Es ist der originale HM-WDS40-TH-I-DS18B20 von papa PLUS i2c Display Anbindung, das die Temperatur ze…
-
Great project - I hope it can be nicely integrated with https://github.com/esp8266/Arduino (e.g., to do the uploading and "serial" monitor using just the ESP and no serial adapter).
I also cross-post…
-
Help wanted for camera support on ~~SB2 13"~~, ~~SB3 13"~~, ~~SL1~~, ~~SL2~~, ~~SP4~~, ~~SP5~~, ~~SP6~~, ~~SP7~~, ~~SGO1~~, ~~SGO2~~ !
**EDIT:** we're also curious about 15" variants: ~~SB2 15"~~, SB…
-
Hi there,
I have recently recieved a Moddable Two.
I have loaded the standard examples as per the Moddalbe instructions and everything works.
I am now trying to load a simple Node Red Flow so far…
-
Hello,
I can not figure it out how to install it on my lolin esp32 lite paaired with a 128x64 oled screen. Can you help me?
-
### The problem
I am able to flash and configure the ESP and the ESP is able to detect the PN532 over I2C but after detection it falls into a loop and does the same thing again and again
i've …
-
Hello,
I am sorry to open an issue but i am not familiar with github and is impossible to leave a private message.
Anyway which xmega is suggested? I would like to make a few boards based on t…