-
It seems that some delay() is needed after writeEEPROM() issued. Without this delay(), following read/write I2C register requests will fail and Arduino board and the I2C Encoder lose their sync.
``…
-
Just gathering information:
* Z80 @3.694700 MHz
* 32k ROM
* 16k banking model in all 4 segments
* Banked graphics memory (custom ASIC)
* Cartridges
* Memory mapped io
* 16/64/128k memory avai…
-
With a (historic) bespoke DHV11 driver, I am seeing the DHV11 RX.DATA.AVAIL bit set when I the driver does not expect it to be.
- #### Context
Because there was originally an issue with some ser…
-
Hi David, this is great project btw.
I'm hoping to try to use it to enable my home heating system to be completely self-contained, at present I'm using the MiHome REST APIs to read and control my eTRV…
-
finally got it fixed:
https://github.com/ValveSoftware/halflife/issues/387#issuecomment-249436648
UPDATE:
https://github.com/ValveSoftware/halflife/issues/387#issuecomment-90850841
its going to be a…
-
In this issue I'm going to present the DMA API I have implemented for the [blue-pill] and that I have used in my recent [robotic application][robot] with the goal of using it to start a discussion abo…
-
Hello,
I'm looking for easy way control relay (220V load) with modbus and input pins (push buttons) on C0135 board.
As far as I understand I need to implement modbus and handling push buttons with G…
-
Both the Atari and Atari5200 code for joystick input lack a reset operation on the sleep counter (i.e., POKE(ATTRACT,0) with ATTRACT being 0x4d for A8 and 0x04 for A5200).
Without this reset just af…
-
First: Thank you very much for providing this library!!!
I have a couple of modules with the nRF24L01+ chip, bought them in bulk at AliExpress and am planning to use them to send sensor data from Fiel…
-
the only bdev example is hardly integrated with fio.
even from "Block Device Layer Programming Guide" it is unclear - who should create a block device ?
If I have a single Samsung nvme in the system…