-
I upgraded from E3 mini V1.2 to V2.0 in my Ender 3 after the part cooling fan mosfet burnt. I really like the v1.2 as it worked well and was very very quite.
After installing the V2.0 board I am h…
RS231 updated
3 years ago
-
Hello, i just installed the 1.22 release.
During the compilation, i had some warnings but i was able to start it. The application seems to not have access to the GPIO (i made tests on lasers and moto…
-
What is the maximum z-feedrate others have been able to handle on the Wilson?
((3rd number in `#define DEFAULT_MAX_FEEDRATE {...}` in Marlin))
My threaded rods gave horrible screeches when my z-axis …
-
**Particle** proton
**Energy** 0.1 GeV
**Distance** 2 m
**Uniform magnetic field** 1 tesla
**Quadrupole magnetic field** 1 tesla/m
**Stepper** DormandPrince745
|Magnetic field |Error Toleranc…
-
The readme file says this is EPICS motor drivers for the following Kohzu controllers: SC-200, SC-400, SC-800 stepper motor controllers.
Does this support the latest version of Kohzu controller ARIE…
-
Hello,
I'm currently trying to drive a stepper motor which drives a linear stage to move something around. I have a fysetc v3.0 TMC2209 connected to a CNC shield v3 which sits on an arduino mega 25…
-
I installed the TMC2208 stepper drivers, and then installed the marlin firmware for new drivers without connections reversed. The Y and Z axis work, but the X axis will grind if I try and drive it, an…
-
## Issue template
- Hardware description: ESP32 and NEMA 17 driven with A4988 on 1/16th step mode
- Installation type: humble
#### Steps to reproduce the issue
I found that i cannot drive the …
-
This drivers work in BTT SKR2 and FLY Gemini V1.
I have tried different speeds for SPI clock: from 100000 to 4000000 Hz.
Log from Fluidd Console:
```
12:19:56 // Klipper state: Ready
12:24:39 $…
-
I would like to monitor the torque output of a stepper motor driven by TMC2209.
I tried to read the stallguard values from TMC 2209 using the provided example - StallGuard_TMC2209.ino.
However, the…
so999 updated
11 months ago