-
libcodec2.so.0.9 is not being found by freedv. This was discovered and reported by Bryan Corkran, VK3KEZ.
-
Is it possible using the pilot one on the receive side to either have the software center on the pilot or using frequency control through CAT have the software shift the radio to center the pilot. Ask…
-
I tried to pip install `pycodec2` after building `codec2` from source.
I got some error.
This is how I installed:
First I installed `codec2`:
```
!sudo yum -y install cmake3
!git clone https:/…
-
There seem to be two problems in the Makefile:
1. sendook does not build as it does not find atouint32_metric.
2. install does not work, as foxhunt is not built by default.
The following change t…
-
Hi! This is an awesome project, and I'm looking forward to seeing where it goes! It looks like an interesting move forwards from using SSDV on high-altitude balloons ( e.g. SSDV over Wenet: https://gi…
-
Tom, N4FWD, reports:
I set up FreeDV and the Icom to listen to the incoming signals. The
intent is to see if there are any other users of FreeDV. So, I have
FreeDV in decode/monitoring mode as I …
-
Does it make sense to add a **2400B** sample to the `wav` directory for completeness?
-
horus_open and horus_rx in codec2 were recently modified to require additional arguments. This causes compile to fail for both git and the released tar.gz source file.
`/home/digger/src/freedv-gui…
-
Please consider creating various folders under the main "HamRadio" grouping and from within that, have:
- calculators (Gtk smithchart, etc)
- cw (ebook2cw,flwkey, twcw,xcwcp,xdemorse)
…
-
Now that 20.04 has gr-osmosdr included and working, would you consider a 3.8 port?