-
Gets installed in `/usr/local/usr/local/...`
```
pi ~/src/vcontrold/build $ sudo make DESTDIR=/usr/local install
[ 5%] Updating version header.
-- Updating version information to 0.98.5-4-gf3e0f2…
-
Hi :-)
First of all, I would recommend that all development and communication is done in English. Viessmann heatings are not only sold in Germany, and if we speak German here, we probably alienate …
-
Using the master branche :
vctrld>setIntervalleLundiChauffage 06:00 22:00
ERR: >FRAMER: addr was still active FE06
>FRAMER: Command send
>FRAMER: unexpected length 8 08
Fehler recv, Abbruch
Feh…
-
Hallo allerseits!
Ich denke, man sollte den Umzug den OpenV-Wikis zum Anlass nehmen, dem Code von vcontrold mal einen Komplettwaschgang zu verpassen. Ich bin jetzt kein C-Profi, aber ich hab einfac…
-
Apparently, the rework is okay, ahd some other stuff has been fixed as well?
What about tagging and creating a "real" release? E. g. with version number 0.99? I was working on a Gentoo ebuild for v…
-
Hallo Zusammen,
ich habe versucht hier in dem Forum ein Hinweis zu bekommen warum bei mir alle SET Kommandos
nicht gehen. zB das Issue
https://github.com/openv/openv/issues/377
löst das Problem be…
-
Hallo allerseits!
Ich habe ein [ebuild für vcontrold für Gentoo Linux](https://bugs.gentoo.org/574964) geschrieben. Wenn man das Paket baut, dann kommt folgende Warnung:
```
* QA Notice: Package…
-
The _Wemos D1 Mini_ is a Sub-3 EUR [ESP8266](https://en.wikipedia.org/wiki/ESP8266) device with integrated WLAN. It can be programmed in C++/Arduino: https://github.com/esp8266/Arduino
I wonder whe…
-
P300 set_addr is still not fully working. While
`
vclient -h localhost:3002 -c "setGwgBetriebsart_M2 Heizen und WW"
`
works
`
vclient -h localhost:3002 -c "unit off" -c "setGwgBetriebsart_M2 1"
…
-
Hi,
I like to monitor and control our Viessmann heating using openhab2 and this adapter.
I downloaded optolink-bin-1.0.0-RC1.zip and nupacked it on an Raspberry Pi 3 running Jessie
I get the foll…