-
```
Currently the ParticleEmitter class only supports setting start/end values for
colors and size. Instead the emitter should support setting "animation tracks"
or "ramps" or "gradients" for these …
-
Hi repetier,
Using a RAMPS 1.4 (motherboard 33) delta config on the current development branch with a RRD smart controller (display 2) enabled the combination of using the flow multiplier and the spe…
-
### What is your question?
I made a 3d printer based on ramps Arduino mega. Then upgraded to MKS tinybee. After connecting all the stuff screen showed error in temp. By hit and trial I narrowed down …
-
I found a potential issue with using the 'saturation' flag to mark pixels with just one good group to suppress ramp fitting.
If you have a pixel that has DQ flags:
[0 4 4 4 4 4 4 2 2 2]
th…
-
my MKS tft is now running on a Ramps 1.4, if I have connected the tft the control via USB (Octoprint) does not work anymore ... is that the same USB port ..? can one adjust this in Marlin?
-
If the Due is not powered but RAMPS-FD is, then the heater outputs (D8-D11) default to an on state.
Redesign FET control circuit to ensure that heater outputs are not active is Due is not powered.
bobc updated
10 years ago
-
Hi! I'm proving an arduino MEGA 2560 + RAMPS 1.4 + Grbl - mega but I can't get the steppers motors move! I used XLoader and Universal GCode Sender. I had proved with simple code uploaded with Arduino …
-
I have seen strange routing like this a couple of times with highway ramps. Organic Maps passes a on-ramp in favor of making a u-turn and taking the on-ramp from the other direction.
In this case tha…
-
```
Currently the ParticleEmitter class only supports setting start/end values for
colors and size. Instead the emitter should support setting "animation tracks"
or "ramps" or "gradients" for these …
-
```
Currently the ParticleEmitter class only supports setting start/end values for
colors and size. Instead the emitter should support setting "animation tracks"
or "ramps" or "gradients" for these …