-
Hallo zusammen,
Adapter läuft soweit sehr gut bei mir. Temperatur abfragen usw... klappt einwandfrei.
Was mir noch nicht ganz klar ist, **wie kann die Betriebsart geändert werden?**
z.B. von "H…
ghost updated
5 years ago
-
With the encouragement of @MichaelDvP in issue #270 I decided to try to commission my Bosch MM200 module.
In testing I had the module configured with the selector dials set to positions 1 and 2, an…
-
http://192.168.69.25/par.cgi
PR001;6;0;8;0;0;0;0;Programm;AUS;NORMAL;WARMWASSER;HEIZEN;ABSENKEN;ABSENKEN BIS;WW Nachl.;ROSTREINIGUNG;HANDBETRIEB;
K0002;6;0;1;0;0;0;0;Asche entleert;Nein;Ja;
h…
-
My boiler has the following config ('RU01' instead of 'BU01'), which is not discovered by the plugin:
{
"id":0,
"name":"Warmwasser",
"type":"HOT_WATER",
"dateCreated":"...",
"deviceTypes…
-
i am preparing a special driver for pr.
below is a description of what the driver does.
i need advice for a few decisions.
1. the name is outdated and misleading (xsns_95_sml.ino) proposal ?
2.…
-
Hi,
i'm trying to figure out, how to deal with the time scheduling messages and to find out, what's the best way to integrate them in fhem.
To get the schedule of a week, i have to chain the follo…
-
Helllo,
while having the same issues as described in #16 I did some research and figured out, that node-red is only listening on TCP 60000 on the IPv6 interface.
With this "iptables -t nat -I PR…
-
FRITZ! DECT 400 - Schalter is not supported so far
-
Hallo,
Adapter läuft bei mir mit einigen Werten und Lesen funktioniert .
Ich würde allerdings gerne die 1xWW Funktion triggern, also setzen.
Sehe aber in der Oberfläche keine Setzdatenpunkte.…
-
The iot-Adapter cannot insert a state as smartdevice which uses the unit " °C". Please remove the unnecessary space character.
nheuk updated
5 years ago