-
After setting up an enviro weather board with the 0.0.9 firmware, powered over USB, I repeated had problems with it stopping sending MQTT message after a few hours. The exact time seemed to vary each …
-
Hello saramonteiro,
Hope you are doing great. I need some information regarding your project like which Lora module you used and its frequency. I am using ESP32 Devkit V1 and Lora RA-02 modules. Is …
-
### Description
Bonjour, je propose que ceux qui le souhaitent laisser leurs coordonnées afin de se rencontrer...
on peut être voisin sans le savoir... et on peut s'échanger des idées... Tous ensem…
-
Hi
I utilize the Sonoff RF Bridge with the RFLink32 image for this device. I control my 433MHz devices using Home Assistant (HA) through the Sonoff Bridge. All my devices operate on the Newkaku pro…
-
Hello,
Was wondering if you have the code to send data to the gateway from a Windows Computer. Understand that your project is using arduino, but I currently do not have it and hopefully I do not hav…
-
```
What steps will reproduce the problem?
Use a Bye Bye Standby 2011 remote to send a key press to my 433Mhz receiver,
which is connected to an Arduino on a PC.
What is the expected output? What do…
-
```
What steps will reproduce the problem?
Use a Bye Bye Standby 2011 remote to send a key press to my 433Mhz receiver,
which is connected to an Arduino on a PC.
What is the expected output? What do…
-
```
What steps will reproduce the problem?
1. Switching to Auto from manual/stabilize (Majority of the cases)
2. Halfway during Auto mission..between waypoints (rare)
3. End of Auto mission
What is …
-
```
What steps will reproduce the problem?
1. Switching to Auto from manual/stabilize (Majority of the cases)
2. Halfway during Auto mission..between waypoints (rare)
3. End of Auto mission
What is …
-
```
What steps will reproduce the problem?
1. Switching to Auto from manual/stabilize (Majority of the cases)
2. Halfway during Auto mission..between waypoints (rare)
3. End of Auto mission
What is …