-
Hi have just set up a mega with a 2 differant ramps 1.6 boards and the 20x4 reprap controller.
I have succesfully loaded the firmware on . all the parts have been used and I know there working
no mp…
-
Hello. Can I connect a laser module to the board for engraving? It is necessary to enable and disable it with commands g-code without PWM. I want to do both like in the RAMPS + ARDUINOMEGA board with …
-
Hi i have problem with firmware upload when EXP2 is connected to board. Problem is caused by the RST pin.
Any way how to flash FW without EXP2 unplugging?
When is RST pin connected to the board i …
-
Since the overhaul to 0.2.2, airport objects - such as the ramps in front of the runways in LVAP, are now showing.
This is caused the update of J_MapLoader to 2.0+.
These objects will now need to …
-
https://www.openstreetmap.org/#map=19/37.40324/-79.15856
The ramp is not properly aligned with either marked crosswalk. Wheelchair user would have to move into Campbell Avenue, then go around corne…
-
[OSM](http://wiki.openstreetmap.org/wiki/Key:highway) lists trunk as the second-most important road in a country, not necessarily a divided highway.
Right now, the car profile and OSRM in general a…
MoKob updated
7 years ago
-
iam having an issue where i try to create 16x256x512 ramps in map.
i select the vertex editing tool and hold CTRL try clicking the Vertices.. all that happens is a red x appears on whatever vertice i…
-
Author Name: **Otto Dassau** (Otto Dassau)
Original Redmine Issue: [10886](https://issues.qgis.org/issues/10886)
Redmine category:symbology
---
Hi,
I would nice, to be able to create relative colo…
-
Anything is wrong with the last revision. My CoreXY printer (Due+ramps_fd v1) drops X-Y steps at different points. I posted my setting many times and I hope You have those, but when not I can post it …
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### Operating system
Linux
### GPU vendor
AMD (ROCm)
### GPU model
RX 6700 XT
### GPU VRAM
12GB
###…