-
I wanted to use a LoRa Radio Node board with an 328 chip and OTA on the V3 stack. It uses the old LMIC library and joins, but does not transfer messages. Serial stops after:
LMIC-node
Device-id…
-
If the user button is held down during startup, force device into the SoftAP.
The sequence is ... hold down the middle button. push and let go of reset, count to 2 and let go of the middle button.
…
-
Please - if you just have a question (i.e. not a bug report or a feature proposal), post in our [forum](https://meshtastic.discourse.group/) instead.
**Describe the bug**
The spec says that the ra…
-
Hi!
I'm trying to connect a BME280 to a TTGO Lora32 V2.1 NEW but I can't get it to work.
I connected the sensor and changed the section in generic.h to:
```
// BME680 sensor on I2C bus
// #…
-
One small issue generated by recent pull request #18. It seems to have broken my ability to link using platformio when I have a copy of LoRaLayer2 in my `lib` directory, but I am building using the co…
-
Arduino version 1.8.13
arduino-lmic v3.3
TTGO T-Beam V1.0
Board ttgo LoRa32 OLED-v1
Upload speed: 921600
Flash freq: 40Mhz
Core debug level: None
I tried to use the lmic v3.3 library, with th…
-
**Describe the feature request**
I have a couple of Heltec units without GPS that I would like to report from a static, hardcoded position. These will be fixed relay nodes with no use for a GPS, whic…
-
HI,
Where can i find setup for SX1276 chip example because we have only for RFM95W chip ?
Thank
Eric
-
**Board:** ESP32 Dev Module
**ESP32 Android Version:** 1.0.5-rc2 (also rc1)
**IDE:** Arduino IDE 1.8.12
Using Example file "SerialToSerialBT.ino", it **crash everytime**, the only way to fix it i…
-
Hi,
when i check display, I do see incoming APRS messages from several ID´s.
So, decoding is working, but then I check, which ID`s have been forwarded to APRS, I cannot see a single one:
e.g, 07…