-
Hi,
I have a T-Beam version T22_V07 (20180711).
GPS and LoRa work great, but I can't connect to a barometric sensor on either I2C bus - the device is not found on 1st I2C bus (2/13) nor 2nd I2C …
-
All the way back to rev 2.0 of the spec, up to current rev 6:
https://www.nxp.com/docs/en/user-guide/UM10204.pdf page 17, **3.1.12 Reserved addresses**,
the bottom 8 and top 8 addresses are reserve…
-
Hey, I stumbled into this when researching this driver chip for use with Arduino. I have a ScanJet 5100c with the same driver powering the motor and I'd like to interface directly with this driver by …
-
I am working on SEN0359 with esp32 Devkit. I used the fingerprintResitration example but there is an error that is :
`In file included from c:\Users\Adevair Technologies\Documents\Arduino\libraries…
-
-
I am using the ELEGOO NANO (ATmega328P & CH340 chip - I installed the latest drivers on it)
I tried to add the 2.4 GHz Band Scanner & Jammer With NRF24L01 code to the nano via Arduino and I am gett…
-
Hello everybody,
I need to configure I2C, and I can't do it using the wire.begin(26, 14) method. Can someone explain to me how I configure the pins for I2C
-
Hi, I was about to have a look into qtflow a bit. When trying to build it, I got the following error:
```
[ 29%] [FLEX][SchematicsScanner] Building scanner with flex 2.6.4
flex version 2.6.4 usag…
-
Is I2C Slave supported in this core?
Zeron updated
4 months ago
-
It works fine on windows(baremetal/vm), however I cannot run on linux.
Env: NixOS(Gnome X11/Wayland AppImage-version baremetal)
, PopOS(Cosmic/Gnome Wayland AppImage-version vm)
, Debian(KDE Waylan…