-
I just finished assembling my module and I'm not able to get any noise out of it. Most of the functionality seems to be working properly, except for the noise and the randomness (but I'm guessing that…
-
[Sent packet 0x00000000 00C3108.txt](https://github.com/qwertychouskie/GM-EandC-Cemu-v2/files/15378948/Sent.packet.0x00000000.00C3108.txt)
Followed the guide provided on Reddit, using Stuart's…
-
Hey- thanks for this awesome library. I am having trouble getting it going on an arduino Mega, using a Futaba TX/RX setup. I have a 2N3904/10k/4.7k TTL inverter. The one thing that is curious is that …
-
I have wired my grbl 0.9j with the inverted Z limit and variable spindle option.
But i have to drive a SSR with the D11 to control the spindle, how to output at his pin a clean 5V to turn on the rela…
onekk updated
8 years ago
-
-
Are you still working and available for this project? I have few questions about the spiral wired antenna in the transponder.
I only get wire with different diameters, has like an equation to adapt t…
-
Hi,
How to setup inverting PWM signal and using +5v to switch off spindle motor?
-
Hi,
I'm Paul, after some research I found this repository. I have had some success with it today for a Panasonic HeatPump.
I did have to make one modification to the code to enable power off fun…
-
EDIT: Possible solution for 2 & 3 being tri-state buffer chip, e.g., 74125 (or variation).
1. If we want to use the GPIO pins of the MCP2221 to toggle flash/reset then we obviously have to roll our…
-
I have a auto leveling sensor which uses 6V~36V(rated voltage of 12V, and I think it's a proximity sensor) and I have no idea how to connect this sensor on the SKR PRO. It worked with 5v on my old Ane…