-
This component should provide easy access to the strain sensor readouts. Support already exists in the esp-idf-lib so this should be a simple wrapper.
This component should also have a means to calib…
-
Trying to run a pair of watering units off of a PB.Hub and would like to have the moisture values from the sensor.
When I set the pin to m5stack_pbhub it gives me an error of "[m5stack_pbhub] is an…
-
### Describe the bug
ADC current meter doesn't work. it stuck a 5.0 or 5.1.
maybe a bad pin ?
bataflight 4.5 RC1 and 4.4
### To Reproduce
alway
### Expected behavior
When I connect the battery,…
-
The following website https://www.adc659.ca/members/ is crawled by Huginn.
It should be ported to the new approach and put on a schedule to crawl every 6 months.
https://huginn-staging.herokuapp.com…
-
CSV Agent does not pass parameter to allow dangerous code to langchain component, and throws an error.
Suggested change to CSV Component :
from langchain_experimental.agents.agent_toolkits.csv…
-
### Test point name
chip_sw_adc_ctrl_debug_cable_irq
### Host side component
Rust?
### Opentitantool infrastructure implemented
Yes
### Silicon Validation (SiVal)
Yes
### Emulation targets
- […
-
This problem was discussed on the SDK forum [here](https://forums.raspberrypi.com/viewtopic.php?p=2232662), where @kilograham thought it sounds like a bug.
The issue arises with single-core FreeRTO…
-
The STM32H533RE.json correctly lists `ADC1`, but I believe it's missing the entry `"kind": "adc"`. This in turn causes embassy-stm32 to not include the ADC module.
-
### The problem
Since few ESPHome versions (or espidf/platformio updates? I didn't change anything related to it) I cannot build my ESP32 firmwares anymore (ESP8266 works fine).
It fails with th…
-
Hello everyone,
I recently encountered a problem while working on a Zephyr project with an ESP32. Specifically, the issue arose when trying to convert raw ADC readings to voltage values. The proble…