-
Hello.
I checked that ADXL344 is very cheapest than ADXL345. This project will works fine with ADXL344 as well, or just for the ADXL345?
Thanks.
-
### ADXL345 from keyestudio.
The code from the wiki work fine on Arduino UNO, but not with the M5Stamp. So the sensor is working.
I tried the example from :
- Adafruit: https://github.com/adaf…
-
# Perfect input shaping - Install the ADXL345 accelerometer on Artillery Sidewinder/Genius Pro | freakyDude's Blog
About installing the ADXL345 accelerometer to calibrate easily input shaping for an …
-
If someone wants to connect two at the same time, here is the config.
`# Obtain definition by "ls -l /dev/serial/by-id/" then unplug to verify
[mcu hotend]
serial: /dev/serial/by-id/***
[mcu bed…
-
Hi, there is a lot of documentation on how to connect an ADXL345 on a CB1 or CM4, and their configuration on Klipper. But I'm in trouble when I connect the BTT-ADXL345 to the BTT-PI by the supplied ca…
-
i try compile 12 ver of klipper ....... but error
Version: v0.12.0-102-g9f41f53c-dirty-20240206_175550-BTT-CB1
Preprocessing out/src/generic/armcm_link.ld
Linking out/klipper.elf
/usr/lib/gcc…
-
Not sure what causes this problem, but I'd though it might be useful to at least post an issue report.
I tried using the quick2wire library with a cheap accelerometer by running the following code:
`…
javl updated
10 years ago
-
Dear all, this is my Klipper, printer.cfg configuration for my Octopus v1.1 referring input shaping:
[adxl345]
cs_pin: PA15
spi_bus: spi3
[resonance_tester]
accel_chip: adxl345
probe_poi…
-
I´m trying connect a BIGTREETECH ADXL 345 Accelerometer.
![image](https://github.com/makerbase-mks/MKS-PI/assets/127941274/cd3e704e-00d2-4150-a823-a2ee6603f4fc)
![image](https://github.com/makerbase…
-
The labels for TX and RX swapped in the block text of svg image.
![2019-07-09 09_58_11-ADXL345_bluetooth_nano5V fzz_ - Fritzing - Schematic View](https://user-images.githubusercontent.com/47461045…