-
hello, I can not connect both btt tft35 and ADXL345 accelerometer via spi to CB1
-
CB1 eMMc on Manta M5P
I have setup the CB1 eMMc as a second MCU configured gpio79 for PI-FAN which is the socket on the M5P.
[mcu cb1]
serial: /tmp/klipper_host_mcu
[heater_fan SoC_fan]
pin: …
-
Hello all,
I am using the latest version, v2.2.1. I flashed a fat32 formatted SD card with the file. Ejected it, plugged it back in, edited the system.cfg file with my wifi ssid and password, saved…
-
Hi,
is it possible to connect a 1 wire temperature sensor on the cb1 with rpi adapter plate on the gipo pins?
-
I'm seeing warnings on the screen like the following and then some kind of crash dump with the message "Rebooting in 5 seconds..."
There are more warning than these listed... but I can't read them of…
-
I have [this](https://a.co/d/bHlh0FM) screen which I know works and I have previously used with KlipperScreen. When I plug it into the Manta, it powers up but says there's no HDMI signal. I've tried s…
-
Actualizacion 2023
Link previos de alguien que cambio la electronica:
https://dyzedesign.com/2018/09/cube-pro-total-conversion-step-by-step-guide/
https://dyzedesign.com/2018/10/our-cube-pro-tota…
-
I get no communication when trying to connect via raspberry pi3b w/USB cable.
firmware uploads, 3V3 is green, firmware.bin renamed
tried 3 cables, all USB ports
removed, reinstalled klipper (ki…
-
Hi!
Just tried to flash a Manta M8P (V2.0) with Katapult / Klipper. It uses a STM32H723 controller.
Compiling and flashing Katapult was no big deal. And since I enabled the Status LED I can see…
-
Anyone running a CB1 with Obico?
I noticed I’m getting still frame video every few seconds vs a steady fps or even buffering
will CB1 ever be ready for obico?