-
Hi,
I have a Smappee Infinity + Genius Gateway and also the EV Wall Business charger as well as a few Smappee Switches. I have also subscribed for the API license.
The support in Home Assistan…
-
I'm using a Smappee EV Line Charger and got OCPP enabled from them.
However, with this integration, the Charge Control switch is not in sync with the charger status as seen below.
**Expected behav…
-
Touchscreen locks up after just a few inputs (any kind) if device is on its side with typecover attached.
EDIT: I was wrong. It occurs when the magnetic Surface charger is attached. It is very repr…
-
Opening an issue for discussing the boot up issue for a PIONIX MicroMegaWatt Charger.
-
Hi @mikuso, i need some help. I have a specific charger that is dropping connection after one minute. One the following simple code, the charger disconnects after one minute. However, if I connect the…
-
I didn't bother pulling any of the config pins low, and it worked OK with a Dell Latitude 3379. (Core i5)
i.e This labtop seems to accept the Arduino sending it the data for a 130W charger, even th…
-
### Describe the bug
Manche OCPP-Wallboxen (bspw. die ältere Wifi-Version der Entratek Power Dot Pro) unterstützen nicht den parameterlosen getconfiguration-Aufruf. Meine Entratek-Wallbox liefert in …
-
Hello
2024.5.5 and the charger was working fine
2024.6 and I get this error log:
This error originated from a custom integration.
###############
Logger: custom_components.evnex
Source: cu…
-
I've connected a Siemens charger, my questions is if now the program without any change can notify me the status of the charger or I've to do any implementation?
In the other hand, I want to start re…
-
TI have [a nice integrated battery charging and 5V boost chip](https://www.ti.com/lit/ds/symlink/bq25895m.pdf) that could replace both the charger and the 5V boost circuit.
Nice things about it are…