-
Hello,
I am using your boards (grasshopper and cricket) to develop an animal tracker by using the LoRa radio not LoRaWAN. To reduce the power consumption from the tracker I will like to use a low ene…
-
Hello,
how far off are you from https://sourceforge.net/projects/ethernut/ HEAD? Any intention to offer it?
Please note, I will be mostly offline until Sep.1
-
After extensive testing with Ublox M8Q and M8B with this library, I have come across a potential issue and am working on documenting it.
Setup:
Murata ABZ module on a custom board. Prior to GNSS.s…
-
Hi,
I am using B-L072Z-LRWAN1 kit including CMWX1ZZABZ-091 module. You mentioned that;
` // SX1276 compatible module connected to SPI1, NSS pin connected to GPIO with label LORA_NSS
uint8_t…
-
### Description of defect
Inability to enter sleep mode (or at least reach expected sleep mode average current) after calling
`static LoRaWANInterface lorawan(radio);` when working with NRF52…
-
6号館-1号館で実施予定
帯域幅を広げた時の通信感度への影響を調べる
-
Hello,
I hope this post finds you well. I am currently working with an SDR and a STM node for testing purposes. I have been receiving packages through the RX chain, but have noticed that they are bei…
-
Hi @janakj ,
I'm trying the new firmware v 1.0.0. I noticed that response to AT+VER is:
`AT+VER?+OK=1.1.06,Mar 31 2022 18:34:02`
(first time I was confused whether I flashed module properly, but th…
-
I'm trying the 1.0.0 with twr-lora-tester and this firmware uses AT+RFQ? to get the info of last received packet.
If the command is not supported, could you please reply with the `+ERR=-1` like the…
-
- Programmer/board type: STLINK V3 set
- Operating system an version: raspberry pi OS buster
- **stlink tools version** and/or git commit hash: 1.7.0-4-gdb9219b
- stlink commandline tool name: st-f…