-
I always get this error while compiling, and don't know what to do, First I thought it was because
"#define CNC_BOOSTERPACK 1 // Do not change!"
This was in the past always "0", but it doesn't…
-
> @S2000Stefan I have just committed an update adding the odometer option to the STM32 drivers. Note that I have not extensively tested this, it is a preview version. Enable in my_machine.h after copy…
-
I'm testing eeprom support with the teensy4 version. Or, I should say I'm trying to test it. My board uses backside pins 24 and 25 for i2c. The code has I2C_PORT 4 selected so should be correct port…
-
I'm using an MSP432P401R LaunchPad to run GrblHAL without anything connected to its GPIO pins. (No CNC_Boosterpack nor any limit switches etc.). And I'm using Universal G-code Sender to communicate wi…
-
Hello @terjeio ,
As I now finished my machine which has two motors for the Y-Axis, I start thinking about the possibility of squaring the gantry while Homing.
Do you think this would in the futur…
-
Is there an i2c eeprom you particularly like to use. Or at least, one that you know works well with your code? Designing a breakout board for the teensy4 version and have room for the IC.
-
Hello, I have downloaded and setup my ESP-idf for this project, I have sucessfully flashes my ESP32 device with hello world program. I have downloaded this program folder but I cannot understand how d…
-
Since this was brought up in a different thread, I thought it a good idea to open a separate issue. Hopefully it will attract a bit more input here.
The encoder support currently works pretty well …
-
They have locked down the design and are in the process of qualifying suppliers so it's probably 2-3 months away. Of course the Corona virus pandemic may cause disruptions. It will use the IMXRT1062 a…
-
I need to arrange a 1 mS timer to call enet_proc_input and enet_poll(). I looked at using driver_delay_ms but that seems like more overhead than necessary. Is there a better way to do that?
From th…