-
hi
I'm new to the world of 3D printing and I downloaded your update E3V2-ManualMesh-5x5-v4.2.2-v2.0.1.bin
On my ender 3v2 printer with a 4.2.2 board it worked without problems until I connected m…
Ab2dx updated
2 years ago
-
### Description
Please add compiles for the Reality `v4.3.1` control board. I received a new Ender 3v2, purchased from a Canadian reseller this week, and that is the version of the control board in…
-
**Describe the bug**
When levelling with a z-offset of anything other than 0, it affects the way the mesh is produced. Consistently reads one side MUCH higher than the other, seems to flip around fro…
-
### Description
CR-Touch doesnt Auto home properly using the marlin firmware.
I already tried adjusting some settings in the firmware.
defining USE_PROBE_FOR_Z_HOMING and BLTouchv
### S…
Loifu updated
7 months ago
-
When compiling for CR4NT220801C10 version of the E3 Free-Run board with BLTouch support, BLTouch will not deploy.
Expected behavior would be that there was support for this board in the Marlin firm…
-
### Description
Whenever I dial in the Z-offset and probe the bed, the Z-offset changes quite significantly (over 0.5mm). The temperature of the bed remains constant. I am using a CR-Touch …
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
I'm writing here to maybe get some additional troubleshooting on this particular issue.
I hav…
-
I recently received a free original Ender 3 that my In-Laws found on FB. I've done all sorts of upgrades for it before I ever turned it on (pervious owner's son used the machine twice and managed to j…
-
Scenario:
Hardware:
RPI3, 4.14.22-v7+, /boot/.firmware_revision: v634741d4199871ab8bd5446a8e63b7e06c1885af (latest by today)
Device: 3D Printer, FTDI Fake Chip: FT232RL, 0403:6001, SerialNumber: …
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
Running the latest firmware. I just upgraded to the Revo CR.
I can do that new PID (MPC?) tun…